Patagonia Sim RacingPatagoniaSim Racing
Patagonia Sim Racing · Free diagnosis

Assetto Corsa Competizione: snap oversteer on throttle — what to change

What it feels like

You get on the power on exit and the rear snaps sideways: spin, or a big correction.

Ready-made ACC setups with every value explained — PDF + JSON, one-time payment.

Buy the pack — US$9.99

Why it happens and what we're after

Exit oversteer (on power): add TC and rear toe-in, and lower diff preload (in ACC high preload tends to snap the rear loose on throttle).

What to change, exactly

Ranges, steps and defaults are the REAL ones for this sim. The amount is expressed in the game's own unit so you can apply it without converting anything.

Parameters flagged as “estimated range” do not come from a verified in-game capture: the direction of the change is right, the exact magnitude may differ on your car.

  1. 1.Traction control (TC)

    Raise ↑ by 11 slider step

    Range: 1 – 8 · Default: 5

    How much it cuts power to stop wheelspin on throttle. Higher = intervenes earlier. The in-game table runs 1 to 8.

    What changes when you move it this way

    More TC = safer in the wet or low grip, but limits acceleration in the dry.

  2. 2.Rear toe

    Raise ↑ by 0.02 °2 slider stepsestimated range

    Range: -0.10 – 0.50 ° · Default: 0.12 °

    Rear axle toe. More toe-in (positive) = more rear stability.

    What changes when you move it this way

    More toe-in greatly stabilises the rear on power, costing a touch of top speed.

  3. 3.Differential preload

    Lower ↓ by 20 Nm2 slider steps

    Range: 20 – 300 Nm · Default: 70 Nm

    How much the diff locks under gentle throttle changes. In ACC, high preload gives exit traction and stability but can oversteer under hard throttle; low preload frees rotation but can understeer on exit.

    What changes when you move it this way

    Less preload frees rotation, but if it's too low the rear won't hook up and you get understeer on power-down.

How to apply it without losing your afternoon

  1. 01Change ONE thing at a time and run three clean laps before judging. Two changes at once and you no longer know which one worked.
  2. 02Start with the first parameter on the list: they are in the order the engine applies them, from the one with most authority to the fine tuning.
  3. 03If the change goes the right way but falls short, repeat the same step again before touching another parameter.
  4. 04If it gets worse, put it back. A setup you don't understand is slower than a baseline you do.

Where this sim stores its setups

ACC stores setups as .json files in Documents/Assetto Corsa Competizione/Setups/<car>/<track>. You can drop the setup there to import it in-game.

Setup pack

If you'd rather skip the trial and error, the ACC pack ships ready-made baselines with every value explained, as PDF and JSON. One-time payment, instant download.

Buy the pack — US$9.99

Want the exact values, not just the direction?

The generator takes your car, your track, the weather, grip and fuel, and returns the full setup with the reasoning behind every number. Free to start.

Car classes covered in this sim: GT3 · GT4

Free to start: you only need an account, no card.

If that wasn't it

Symptoms get confused with each other: what feels like poor traction is very often oversteer on throttle. These are the other diagnoses for this sim.

The same problem in other sims

Same symptom, different parameters: each game exposes different sliders, with other units and other ranges.