Le Mans Ultimate: tyres not coming up to temperature — what to change
What it feels like
The first laps the car slides everywhere and the tyres take forever to switch on.
Ready-made LMU setups with every value explained — PDF + JSON, one-time payment.
Buy the pack — US$7.99Why it happens and what we're after
Cold tyres (typical on out-laps and night stints): raise pressures so they reach their temperature window faster.
What to change, exactly
Ranges, steps and defaults are the REAL ones for this sim. The amount is expressed in the game's own unit so you can apply it without converting anything.
Parameters flagged as “estimated range” do not come from a verified in-game capture: the direction of the change is right, the exact magnitude may differ on your car.
1.Front tyre pressure
Raise ↑ by 6 kPa6 slider stepsestimated rangeRange: 110 – 180 kPa · Default: 131 kPa
Cold front pressure (kPa). LMU targets a hot temperature/pressure window; you start below target because pressure rises with heat. (estimated range)
What changes when you move it this way
Faster warm-up and sharper response, but less contact patch and peak grip; too high and it slides.
2.Rear tyre pressure
Raise ↑ by 6 kPa6 slider stepsestimated rangeRange: 110 – 180 kPa · Default: 131 kPa
Cold rear pressure (kPa): affects traction and rear stability. Same target window as the front. (estimated range)
What changes when you move it this way
Twitchier rear with less peak grip; can step out on power.
How to apply it without losing your afternoon
- 01Change ONE thing at a time and run three clean laps before judging. Two changes at once and you no longer know which one worked.
- 02Start with the first parameter on the list: they are in the order the engine applies them, from the one with most authority to the fine tuning.
- 03If the change goes the right way but falls short, repeat the same step again before touching another parameter.
- 04If it gets worse, put it back. A setup you don't understand is slower than a baseline you do.
Where this sim stores its setups
LMU stores setups as .svm files in [Steam]\steamapps\common\Le Mans Ultimate\UserData\player\Settings\<track>\ (one folder per circuit). To import a community setup you drop the .svm into the matching track folder and load it from the Setup Area screen. It inherits the rFactor 2 system.
If you'd rather skip the trial and error, the LMU pack ships ready-made baselines with every value explained, as PDF and JSON. One-time payment, instant download.
Buy the pack — US$7.99Want the exact values, not just the direction?
The generator takes your car, your track, the weather, grip and fuel, and returns the full setup with the reasoning behind every number. Free to start.
Car classes covered in this sim: Hypercar · LMGT3 · LMP2 · LMP3 · GTE
Free to start: you only need an account, no card.
If that wasn't it
Symptoms get confused with each other: what feels like poor traction is very often oversteer on throttle. These are the other diagnoses for this sim.
- Understeer on corner entryYou turn in and the car keeps going straight: it washes wide before the apex.
- Mid-corner understeerMid-corner, at steady speed, the car refuses to hold the line and you have to unwind the wheel.
- Understeer on corner exitAs you get on the throttle the car pushes wide and runs out of road on exit.
- Oversteer on corner entryAs you release the brake and turn in, the rear steps out and the car rotates too much before the apex.
- Mid-corner oversteerMid-corner the rear keeps sliding on its own and you are correcting with the wheel the whole way through.
- Snap oversteer on throttleYou get on the power on exit and the rear snaps sideways: spin, or a big correction.
- Unstable under brakingBraking hard in a straight line the car moves around, the rear tries to come round or you lock up.
- No traction on corner exitOn exit the driven wheels spin and the car won't hook up: you lose time down the next straight.
- Tyres overheatingGrip falls off after two or three laps and temperature or pressure climbs past the window.
- Car bottoming outOver fast sections or compressions the floor hits the track, the car bounces and you lose grip exactly there.
- Unstable over kerbsTouch a kerb and the car jumps, gets unsettled, and you end up avoiding kerbs to keep it.
The same problem in other sims
Same symptom, different parameters: each game exposes different sliders, with other units and other ranges.